A. Review Stage
Instructions about final paper and figure submissions in
this document are for IEEE journals; please use this
document as a “template” to prepare your manuscript. For
submission guidelines, follow instructions on paper
submission system as well as the Conference website.
Please check with your editor on whether to submit your
manuscript by hard copy or electronically for review. If hard
copy, submit photocopies such that only one column
appears per page. This will give your referees plenty of
room to write comments. Send the number of copies
specified by your editor (typically four). If submitted
electronically, find out if your editor prefers submissions on
disk or as e-mail attachments.
If you want to submit your file with one column
electronically, please do the following:
--First, click on the View menu and choose Print
Layout.
--Second, place your cursor in the first paragraph. Go
to the Format menu, choose Columns, choose one column
Layout, and choose “apply to whole document” from the
dropdown menu.
--Third, click and drag the right margin bar to just over
4 inches in width.
The graphics will stay in the “second” column, but you can
drag them to the first column. Make the graphic wider to
push out any text that may try to fill in next to the graphic.
of this document, please download the electronic file,
ieeeconf_letter.dot (for letter sized paper: 8.5” x 11”) or
ieeeconf_A4.dot (for A4 sized paper: 210mm x 297mm)
and save to MS Word templates directory. The template to
produce your conference paper is available at
www.paperplaza.net/support/support.html. To create your
own document, from within MS Word, open a new
document using File | New then select ieeeconf_letter.dot
(for letter sized paper) or ieeeconf_A4.dot (for A4 sized
paper). All instructions beyond this point are from IEEE.
Instructions about final paper and figure submissions in
this document are for IEEE journals; please use this
document as a “template” to prepare your manuscript. For
submission guidelines, follow instructions on paper
submission system as well as the Conference website.
If your paper is intended for a conference, please contact
your conference editor concerning acceptable word
processor formats for your particular conference.
When you open ieeeconf_letter.doc or ieeeconf_A4.doc,
select “Page Layout” from the “View” menu in the menu
bar (View | Page Layout), which allows you to see the
footnotes. Then type over sections of the sample file, either
This work was supported in part by the U.S. Department of Commerce
under Grant BS123456 (sponsor and financial support acknowledgment goes
here). Paper titles should be written in uppercase and lowercase letters, not
all uppercase. Avoid writing long formulas with subscripts in the title; short
formulas that identify the elements are fine (e.g., "Nd–Fe–B"). Do not write
"(Invited)" in the title. Full names of authors are preferred in the author field,
but are not required. Put a space between authors' initials.
F. Anderson is with the National Institute of Standards and Technology,
Boulder, CO 80305 USA (corresponding author to provide phone: 303-555-
5555; fax: 303-555-5555; e-mail: author@ boulder.nist.gov).
S. B. Niles, Jr., was with Rice University, Houston, TX 77005 USA. He
is now with the Department of Physics, Colorado State University, Fort
Collins, CO 80523 USA (e-mail: author@lamar. colostate.edu).
T. C. Donald is with the Electrical Engineering Department, University of
Colorado, Boulder, CO 80309 USA, on leave from the National Research
Institute for Metals, Tsukuba, Japan (e-mail: author@nrim.go.jp).
